Products
FLIP UNIT FOR INSPECTION
Classification:
① Visual inspection of the front side of slide by turning it over 90 °, then placing the slide in initial position and output. This station is used to check for problems caused by lamination, such as air bubbles, and the back side will be checked after curing.
② Gripping units do not crush or bend slides.
③ Protected by a safety light curtain, which stops all movements when it is blocked/covered and continues only when it is restored.
④ Securely lock the module to prevent falling off during the flipping.
⑤ LED light above equipped, illumination level 1000 LUX.
② Gripping units do not crush or bend slides.
③ Protected by a safety light curtain, which stops all movements when it is blocked/covered and continues only when it is restored.
④ Securely lock the module to prevent falling off during the flipping.
⑤ LED light above equipped, illumination level 1000 LUX.
Keywords: filter, filter, hydraulic accessories
FLIP UNIT FOR INSPECTION
TECHNICAL SPECIFICATION:
| Name | Module Flip Unit for Visual Inspection |
| Power Source | AC 400V, 3 phase, 50/ 60 Hz |
| Operating Cycle Time | ≤ 22 s (Excl. Inspecting Time) |
| Operating Air Pressure | 0.6 - 0.8 Mpa |
| Power Peak | 2.5 kw |
| Breakage Rate | ≤ 0.001% |
Previous
Next
Previous
Next
Related Products
Online consultation
Wuxi Leantaic New Energy Equipment Co.,Ltd.
ADDRESS: No. 674, Chengtang Village, Huishan Economic Development District, Wuxi, Jiangsu Province, China
MOBILE: +86 18014221870(WeChat)
E-MAIL: huangcheng@leantaic.com.cn
Copyright©2024 Wuxi Leantaic New Energy Equipment Co.,Ltd.
