Products
① Visual inspection of the front side of slide by turning it over 90 °, then placing the slide in initial position and output. This station is used to check for problems caused by lamination, such as air bubbles, and the back side will be checked after curing.
② Gripping units do not crush or bend slides.
③ Protected by a safety light curtain, which stops all movements when it is blocked/covered and continues only when it is restored.
④ Securely lock the module to prevent falling off during the flipping.
⑤ LED light above equipped, illumination level 1000 LUX.
② Gripping units do not crush or bend slides.
③ Protected by a safety light curtain, which stops all movements when it is blocked/covered and continues only when it is restored.
④ Securely lock the module to prevent falling off during the flipping.
⑤ LED light above equipped, illumination level 1000 LUX.
① Frames automatically dispensed with glue and sealed with the module, the four sides are securely locked in place to further protect the cells inside.
② Smooth moving of the gluing device to ensure the glue evenly distributed.
③ Soft suction cup which will not leave marks on the module surface.
④ Driven by servo motor, transmitted by ballscrew and directed by linear track, makeing frame positioning accurate.
⑤ Simple operation and easy to adjust.
② Smooth moving of the gluing device to ensure the glue evenly distributed.
③ Soft suction cup which will not leave marks on the module surface.
④ Driven by servo motor, transmitted by ballscrew and directed by linear track, makeing frame positioning accurate.
⑤ Simple operation and easy to adjust.
① Compatible with different junction-box (single or triple-split).
② Multi soldering mode available.
③ High-temperature-resistant soldering head, no tailing adhesive.
④ Long-life soldering head and stable welding quality.
② Multi soldering mode available.
③ High-temperature-resistant soldering head, no tailing adhesive.
④ Long-life soldering head and stable welding quality.
① Potting of the configured A and B glue into the junction boxes to act as a seal. Protecting of the junction box from water ingress.
② Compatible with different junction-box (single or triple-split).
③ Sharing a gluing system with auto framing machine.
② Compatible with different junction-box (single or triple-split).
③ Sharing a gluing system with auto framing machine.
① Palletizing of the modules on the line for at least 4 hours curing.
② Capacity determined line length, customizable.
③ Smooth transport of modules on the curing line without jitter or hysteresis even under full load.
④ Equipped with module detection and anti-crush function.
② Capacity determined line length, customizable.
③ Smooth transport of modules on the curing line without jitter or hysteresis even under full load.
④ Equipped with module detection and anti-crush function.
① Main structure: module transport unit with alignment, suction and labeling unit, vacuum system, etc.
② Smooth transfer of the suction and labelling system, precise and fast suction and labelling, soft contact during labelling and protection of the modules.
③ Rolling to stick bar code and nameplate to ensure a tight adhesion.
② Smooth transfer of the suction and labelling system, precise and fast suction and labelling, soft contact during labelling and protection of the modules.
③ Rolling to stick bar code and nameplate to ensure a tight adhesion.
Wuxi Leantaic New Energy Equipment Co.,Ltd.
ADDRESS: No. 674, Chengtang Village, Huishan Economic Development District, Wuxi, Jiangsu Province, China
MOBILE: +86 18014221870(WeChat)
E-MAIL: huangcheng@leantaic.com.cn
Copyright©2024 Wuxi Leantaic New Energy Equipment Co.,Ltd.
